News:

Welcome to our club, we are always looking for improvements to the site, if you have any suggestions please post them up...

Main Menu

Bought me a new trolley jack

Started by madgaz, April 25, 2007, 05:02:44 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

madgaz

WooHoo...seen as any 165 is in the air more than on the ground I thought it was time to invest...

...got a 3 ton trolley jack from costco for only 60 quid :o

It has low entry at 89mm and lifts to 550mm...

...fookin marvelous for that money 8)

Weighs 40kg though...nearly broke my back putting it in the shopping trolley :D

Seriously wanting another GT4 NOW god dam it!!!

RobbieMcVee

Should have opened another one to lift it in there for ya ;-)
PHEW!!!!

Welshman

good thinking , ive done a similar thing but i bought a 2 post ramp hehe

madgaz

Quote from: Welshman on April 26, 2007, 12:15:38 PM
good thinking , ive done a similar thing but i bought a 2 post ramp hehe

Well if I could have picked one of those up for 60 quid I would have done :P :o ;D :D

But I couldn't have anyway cos we're moving soon ;D ;D ;D

Seriously wanting another GT4 NOW god dam it!!!

alwayzsidewayz

Nice one Gaz, I too have invested in lifting hardware, I now own a 2 tonne engine hoist with load leveller!!!

It weights like 90kgs and is a bit big, but its red an shiney so I likes!
Car 22 in the TSS, red celica ST165, with lots of go faster bits.

21 years old and still looking sexy!! the car that is...not me!

The Doctor


VaunB_205

wish i had one now, doin exh manifold gasket replace, and replacing snapped off studs  >:(

Wot a mission, got all the stuff off now, just to drill out the 2 bust studs (was like that when i bought it, honest guv  ::))
and fit replacements.

Enough for today, gonna play some Ghost Recon AW  :)

mr3sgte

don't secondhand car lifts suffer from pivot pin failure

nick280

I'm quite lucky in the way that my garage is soooooooooo big everybody just leaves there kit with me because they know the work is going to get done here anyhow ;D

I have a 2 tonne & 3 tonne trolley jack, 1 tonne engine crane, 500kg engine stand, 2 tonne axle stands and 3 tonne axle stands.

Nobody left a 2 poster lift yet though, I'm working on that one though :lol:
Slightly Tweaked By The Mighty Scott

madgaz

Quote from: mr3sgte on April 30, 2007, 08:44:53 PM
don't secondhand car lifts suffer from pivot pin failure

I guess any second hand equipment could have any/some catastophic failure of some kind ???

My second hand car however has NOT suffered brake failure yet ;)

And as for your garage Nick...you lucky lucky bar steward ;D

Seriously wanting another GT4 NOW god dam it!!!

dt4

Im after a MIG welder if you see one

nick280

Slightly Tweaked By The Mighty Scott