Print Page - st202 alloys on to st205

Title: st202 alloys on to st205
Post by: rhino on March 19, 2009, 07:41:10 PM

Hi Folks

I was wondering if the pcd of the two models is the same (must be surely?) and if the wheel nuts from one model are interchangeable with the other model...ie if I take some rims off a 202 and put them on a 205, can I use the wheel nuts off the 202 on the 205...or will the thread pitch be different? Just in case the rims require different nuts than I have available (i'll have flat and angled on me, but not curved seat).

I know there might be issues with brake calliper clearance...but is there any other potential problems?

Cheers for any help

Karl

Title: Re: st202 alloys on to st205
Post by: Driveby on March 19, 2009, 08:57:31 PM

Would have thought the nuts would be the same, caliper clearance would be your main headache.

Title: Re: st202 alloys on to st205
Post by: fifegt4 on March 20, 2009, 10:47:53 AM

PCD = 5x100
Wheel studs 12x1.5mm
The PCD is the same but you will most likely need spacers to clear the calipers on the front.

Title: Re: st202 alloys on to st205
Post by: rhino on March 20, 2009, 11:52:15 AM

thanks fellas...fingers crossed 8)

GT4EC - The GT-Four Enthusiasts Club

General Category => The Chill Out Room => Topic started by: rhino on March 19, 2009, 07:41:10 PM