GT4EC - The GT-Four Enthusiasts Club
General Category => The Chill Out Room => Topic started by: bazza2541 on March 15, 2008, 08:11:47 pm
-
(http://koti.mbnet.fi/tazka/st185diffuser.jpg)
-
Very evo 9 lol never been very sure if i like them or if there any use?
-
thats the first aftermarket part that i quite like. Not at all in your face, and uses the majortity of 'shape' of the original part. Nice find
-
Very nice item, I like it a lot. And I normally hate aftermarket body panels. Only one question - how far forward does it go and is it properly done or just cosmetic? A low hanging diffuser like that will act like an air brake under the rear unless it is matched to the underbody fairly well.
-
Its a photochop. Because the design of crates mean that to put in a 'proper' diffuser, you'd have to remove the fuel tank.
-
you could actually do this and blend it with the fuel tank and it would work pretty efficiently
-
NAh I reckon you could wrap one round it fairly well, the shape of the tank cover is fairly close already. I'd been wondering about doing an entire-body underpan but its yet another of those plans that goes un-done due to lack of time and finance.
-
would it be worth it i think not, well not with the roads over here
-
If you boys had bought proper 4's you wouldn't need a diffuser.
-
yeah well can't wait to see you going over that hump back bridge flat out beside your house with all 23stone of you in there........ i can see the floor pan going
-
Tein is my friend. :)
-
you got tein shocks on your seats...... damn thats smart
-
LOL bazza, the 165 has the aerodynamics of a house brick ;D
Not sure it would be worth while myself either but it would cover the ugly tank.